Skip to content

Build Independently confirmed3 publishers 3 min read Published Updated

Digit 5's 20-hour day leaves nine minutes of slack per 108-minute cycle beyond running and charging

Agility showed Digit 5's specifications on September 15 and expects general availability by the end of 2027. That leaves the barrier-free safety architecture two years to produce field data for buyers weighing a 284-pound biped.

The Engineer · Build desk

Send a correction

What happened

  • Agility unveiled Digit 5 on September 15, a humanoid built to work close to employees without the protective barriers that normally fence industrial robots off from people.
  • The company is pitching a proposed public listing at a $2.5B pre-money valuation, paired with a Digit 5 customer rollout in 2027.
  • Digit 5 lifts 50 pounds repeatedly, which Agility calls a 40% payload increase over Digit 4, using a revised leg design built around the company's cycloidal actuators.

Why it matters

  • What it limits constraint The 10:1 ratio only pays out if a dock is free on arrival, and one dock sits behind about eleven robots at perfect scheduling, so any queue spends the nine minutes of per-cycle slack.
  • Who has to decide decision A buyer putting an unfenced 284-pound biped next to staff in 2027 has to decide whether to accept a supplier safety case while ISO 25785-1, which Agility is helping write, is still in development.
  • Who's exposed exposure Public shareholders would be pricing repeatable deployment about two years before the early-access cohort generates safety and uptime data from work outside fenced cells.
  • What's now possible capability Because grippers attach through ISO-standard flanges, an integrator can fit a third-party end effector without designing a new mount, taking that choice out of Agility's catalogue.

When a person gets close to Digit 5, Agility describes three possible responses: multiple sensors feed its human-detection software, which can steer the robot around the person, stop it, or lower it into a seated position [2]. A separate, independent safety controller can also intervene when someone gets too close, and visual and auditory cues signal where the robot intends to move [2]. The second controller is the good engineering here. It does not have to trust the perception stack that just decided nobody was there. Sitting down is also a defined safe state for a 284-pound machine that balances on two legs [10].

The uptime number is checkable. Agility says the battery runs 90 minutes and is designed to recharge autonomously in nine [5], and it calculates that the resulting 10:1 ratio supports over 20 productive hours in a 24-hour period, against Digit 4's 2:1 [12]. A full cycle is 99 minutes, so a day holds 14.5 of them and 21.8 hours go to work [22]. Hitting exactly 20 productive hours needs 13.3 runs of 90 minutes, one every 108 minutes, which leaves nine minutes per cycle for the walk to the dock and any wait once it arrives [23]. Nine minutes is not a generous budget for floor traffic.

Charge ratios saturate. A 2:1 machine, scheduled perfectly, works 16 hours out of 24; a 10:1 machine works 21.8, so five times the ratio buys 5.8 hours, or 36% [24]. Each robot also occupies a dock nine minutes out of every 99, which puts one dock behind about eleven robots at perfect scheduling [25]. After that, the remaining uptime is in stops and waits, including the conveyor and warehouse-system handoffs that Agility Arc is meant to coordinate [17].

On safety evidence, Agility says the previous Digit was the first humanoid to pass an independent field evaluation on a customer production line, against industrial safety requirements administered by the Occupational Safety and Health Administration [8]. That was one line at one customer. For the barrier-free claim to transfer, another floor needs comparable aisle widths and pedestrian density, and the buyer needs a document to check it against. ISO 25785-1, an international humanoid safety standard, is still being developed, and Agility is contributing to it and to the ANSI/A3 technical report for dynamically stable industrial mobile robots [9]. Agility is also NVIDIA's first humanoid launch partner for Halos for Robotics, pairing Digit's safety architecture with IGX Thor and Halos Core [11].

The hardware supports a wider pitch than the tote-moving that has dominated earlier Digit deployments [7]: 50 pounds lifted repeatedly, which Agility calls 40% more than Digit 4 and implies roughly 36 pounds before [3][21]; a 7.2-foot reach into shelving built for people [13]; and grippers on ISO-standard mounting flanges [4]. Agility plans to train Digit 5 for depalletizing, machine tending, kitting, sequencing, inspection and palletizing [6]. Early access comes in the first half of 2027, general availability by the end of it [14].

The financing runs ahead of that evidence. Agility said in June it had agreed a transaction with Churchill Capital Corp XI [16], and the plan pairs the 2027 rollout with a proposed listing at a $2.5B pre-money valuation [15]. Peggy Johnson, who took over as CEO in March 2024 after running Magic Leap, has the rollout; Jonathan Hurst remains chief robot officer [18][19]. In an August essay on physical AI, Hurst argued that software remains constrained by the machine executing it [20].

What to watch

  • Whether the first-half 2027 early-access customers publish uptime and incident data from unfenced operation, not just tote-moving runs.
  • Publication of ISO 25785-1 and the ANSI/A3 technical report, and whether Digit 5 is assessed against the final text.
  • Whether the Churchill Capital Corp XI transaction closes at the $2.5B pre-money valuation Agility is pitching.

Clarity's read

What the record supports and how the coverage leans. The claims behind it follow.

Reality

Evidence40
Adoption20
Hype gap+25
Incentives80
Confidence55

Perspective Coverage

3 publishers
Builder
Builder 40%
Operator
Operator 40%
Investor
Investor 20%
Why these scores

Claim ledger

Ranked by verification strength, evidence, and original report placement.

  1. [1]

    Agility unveiled Digit 5 on September 15th, presenting a stronger, faster-charging humanoid designed to work near people without the protective barriers common around industrial robots.

    Reported SupportedView cited source
  2. [2]

    Multiple sensors feed Agility's human-detection software, which can direct Digit to avoid a person, stop or lower itself into a seated position; visual and auditory cues communicate intended movement, while an independent safety controller can intervene when a person gets too close.

    Reported SupportedView cited source
  3. [3]

    Agility says Digit 5 can repeatedly lift 50 pounds, a 40% payload increase from Digit 4.

    Reported SupportedView cited source
  4. [4]

    A revised leg design uses Agility's cycloidal actuators to handle repetitive lifting, while interchangeable grippers attach through ISO-standard mounting flanges.

    Reported SupportedView cited source
  5. [5]

    Agility says the Digit 5 battery runs for 90 minutes and is designed to recharge autonomously in nine minutes.

    Reported SupportedView cited source
  6. [6]

    Agility plans to train Digit 5 for depalletizing, machine tending, kitting, sequencing, inspection and palletizing.

    Reported SupportedView cited source
  7. [7]

    Digit 5's specifications support a wider product pitch than the tote-moving work that has dominated earlier Digit deployments.

    Reported SupportedView cited source
  8. [8]

    Agility says the previous Digit became the first humanoid to pass an independent field evaluation on a customer production line against industrial safety requirements administered by the Occupational Safety and Health Administration.

    Reported SupportedView cited source
  9. [9]

    Agility is contributing to the ANSI/A3 technical report being developed for dynamically stable industrial mobile robots and to ISO 25785-1, an international humanoid safety standard.

    Reported SupportedView cited source
  10. [10]

    Industrial buyers need a repeatable basis for assessing a 284-pound autonomous machine moving around employees, equipment and inventory.

    Reported SupportedView cited source
  11. [11]

    Agility is NVIDIA's first humanoid launch partner for Halos for Robotics, pairing Digit's safety architecture with NVIDIA IGX Thor and Halos Core infrastructure.

    Reported SupportedView cited source
  12. [12]

    Agility calculates that the 10:1 run-to-charge ratio can support over 20 productive hours in a 24-hour period, compared with Digit 4's 2:1 ratio.

    Reported SupportedView cited source
  13. [13]

    Digit 5 stands 5 feet 11 inches and can reach 7.2 feet, allowing it to access equipment and shelving intended for human workers.

    Reported SupportedView cited source
  14. [14]

    Agility expects early access during the first half of 2027 and general availability by the end of that year.

    Reported SupportedView cited source
  15. [15]

    Agility's plan pairs Digit 5's 2027 customer rollout with a proposed listing carrying a $2.5B pre-money valuation.

    Reported SupportedView cited source
  16. [16]

    Agility said in June it had agreed a transaction with Churchill Capital Corp XI.

    Reported SupportedView cited source
  17. [17]

    Agility Arc, its cloud-based fleet platform, is intended to coordinate handoffs with conveyors, autonomous mobile robots and warehouse-management systems.

    Reported SupportedView cited source
  18. [18]

    Peggy Johnson took the CEO role at Agility in March 2024 after serving as Magic Leap's CEO; before Magic Leap she spent six years running business development at Microsoft and 24 years in leadership roles at Qualcomm.

    Reported SupportedView cited source
  19. [19]

    Jonathan Hurst remains Agility's chief robot officer.

    Reported SupportedView cited source
  20. [20]

    In an August essay on physical AI, Hurst argued that software remains constrained by the machine executing it.

    Reported SupportedView cited source
  21. [21]

    A 40% payload increase to 50 pounds implies a Digit 4 payload of about 36 pounds.

    Derived Supported
  22. [22]

    A run-plus-charge cycle of 90 minutes working and nine minutes charging is 99 minutes, so a 24-hour day holds about 14.5 cycles and about 21.8 hours of work at zero overhead.

    Derived Supported
  23. [23]

    Reaching exactly 20 productive hours in 24 takes 13.3 runs of 90 minutes, one every 108 minutes, leaving nine minutes per cycle beyond the 99 minutes of running and charging.

    Derived Supported
  24. [24]

    A 2:1 run-to-charge ratio yields 16 working hours in 24 at zero overhead against 21.8 hours at 10:1, so a fivefold ratio increase adds 5.8 hours, or about 36%.

    Derived Supported
  25. [25]

    At perfect scheduling one charging dock can serve about eleven robots, because each robot needs nine minutes of dock time in every 99-minute cycle.

    Derived Supported

Sources

3 independent publishers whose own reporting we read for this story.

  1. mezha.net

    1 article · September 15, 2026

    Agility Robotics представила Digit 5, який працює поруч із людьми без бар’єрів
  2. runtimewire.com

    1 article · September 15, 2026

    Agility unveils Digit 5 as it pitches a $2.5B pre-money valuation
  3. the-decoder.com

    2 articles · September 15, 2026

    Agility Robotics says its new Digit 5 robot can work next to people without safety fences

Topics and entities

Entities